Bill's Early Bronco build
Re: Bill's Early Bronco build
Had to cut holes in the buckaroo hood from wild horses,, I went slow,,,
- Jeremyrowell
- Site Admin
- Posts: 352
- Joined: Wed Feb 29, 2012 11:28 pm
- Location: Bakersfield, CA
Re: Bill's Early Bronco build
I don't understand what's taking you so long with this build!
Re: Bill's Early Bronco build
I made rockliders out of .188 3x3 square tubing,, I put 1 inch holes in them , bought a dimple die , 2 actually , I bought one by mistake so it was cheaper to sell it to Robert than to send it back. 15 samckers , good deal
Re: Bill's Early Bronco build
I wanted to put some LED strip lights in the rocksliders so indirect light could be seen inside of them , through the holes. So I capped the other end with some stainless screws
Re: Bill's Early Bronco build
This was a little time consuming because I had to cut the back off of the 3x3 to be able to use the dimple die , then weld it back..
Re: Bill's Early Bronco build
This crap takes time,, I have a sigfnificant gap between the door and window frame , so I found the measurements so I could see all the places that were screwed up
- Attachments
-
- Door%20measurements.jpg (6.64 KiB) Viewed 6297 times
Return to Readers Rides- Post Pics Here
Who is online
Users browsing this forum: No registered users and 9 guests